Preparing For The Installation - Hughes HX90 Installation Manual

Chapter 2 • Preparing for installation
12
1039456-0001 Revision A
This summary focuses on installation of the satellite router, but also includes some
information on related tasks such as antenna installation and pointing. The tasks
listed below are the main installation tasks, but these are not all of the installation
tasks.
Complete all steps in the order they are presented in this installation guide unless
you have a specific reason for doing them in a different order. In any case, make sure
all steps are completed. You must install the antenna before the satellite router can
be commissioned. Then you point the antenna as part of the router commissioning
procedure.
Details for the satellite router installation tasks are included in later chapters in this
guide.

Preparing for the installation

• Make sure you have all items required for installation, including the Installation
Reference Sheet and installation specification, all equipment to be installed, and
required tools for the outdoor equipment.
• Consumer installations only: Make sure the customer's computer meets the
requirements listed in Computer and networking requirements on page 17.
• Conduct a site survey.
• Assemble and install the antenna and radio as instructed in the antenna
installation guide.
Installing the satellite router
• Connect the transmit and receive cables.
• Connect the router to the installer laptop.
• Connect the power supply.
• Power up the router and observe the LEDs to verify normal operation.
Commissioning the router and pointing the antenna
• Upload the
sbc.cfg
• Enter the antenna location and satellite and radio parameters.
• Point the antenna.
• Register the satellite router.
Completing the installation
• Confirm that all files are current.
• Connect the router to the customer's computer.
file (if you are instructed to upload it).