Table of Contents
Advertisement
Troubleshooting reference diagram
Chapter 8 • Troubleshooting
90
1039456-0001 Revision A
CAUTION
When this installation guide instructs you to power cycle the router, you should
remove and then re-apply power. If the satellite router uses an AC/DC power
supply, disconnect the AC power cord from the power source (power strip, wall
outlet, or surge protector). If the satellite router uses a DC/DC power supply,
disconnect the DC input cable connector from the router's power supply. In
either case (AC/DC or DC/DC), do not unplug the power cord from the satellite
router's rear panel. Doing so could result in static electricity discharge that could
shock you and/or damage the router.
If you need to use any of the troubleshooting procedures provided in this chapter,
you may find it useful to refer to Figure 68. This diagram shows all power and cable
connections for a properly installed HX90 satellite router.
Figure 68: Troubleshooting reference diagram
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
