Confirming The Receive Signal; Confirming The Transmit Signal - Hughes HX90 Installation Manual

Confirming the receive signal

To confirm that the router is properly receiving satellite signals:
1. At the System Control Center, click the
The Reception Information page appears.
2. In the Receive Status field, check the RxCode.
If the RxCode is Receiver operational (
properly; proceed to Confirming the transmit signal on page 93.
If any other RxCode appears, the router is not receiving signals properly. Click the
RxCode
, and follow the troubleshooting procedure that appears. Click the
RxCode
Note: The RxCode shown is an example.

Confirming the transmit signal

To confirm that the router is properly transmitting signals to the satellite:
1. At the System Control Center, click the
The Transmission Information page appears.
2. In the Transmit Status field, check the TxCode.
If the TxCode is
signals properly; proceed to Confirming that TCP Acceleration is operational on
page 94.
for explanation of the problem and/or troubleshooting information.
Figure 70: Reception Info page
Transmitter Ready (RxCode 8)
link.
Reception Info
) the router is receiving signals
RxCode 5
link.
Transmission Info
the router is transmitting
Chapter 8 • Troubleshooting
1039456-0001 Revision A
93