Transmit Antenna Pointing - Ku-Band - Hughes HX90 Installation Manual

Transmit antenna pointing — Ku-band
Chapter 4 • Commissioning the satellite router
50
1039456-0001 Revision A
Note: This section applies to Ku-band installations only.
1. On the Receive Antenna Pointing screen, select the Perform ACP checkbox if your
service provider offers automatic cross-polarization (ACP).
Note: The Perform ACP checkbox is automatically checked if ACP is enabled at the
NOC. If it is not automatically checked, likely reasons are that the NOC does
not support ACP, ACP is not enabled at the NOC, or there is a problem with the
ACP server.
Note: The ACP test is required for Ku-band customers in the United States and
Canada; for customers outside the United States and Canada, it is optional.
Next
2. Click .
3. On the Transmit Antenna Pointing screen, click
cross-polarization test.
Figure 32: Initiating a manual cross-polarization test
Be ready to adjust the antenna. For antenna adjustment instructions, see the
antenna installation guide.
Note: The manual cross-polarization test times out 3 to 5 minutes after you click the
Manual button. Therefore you must complete any antenna adjustments
required to achieve maximum transmit isolation within this time.
Manual
to initiate the manual