Leds On Power-Up - Hughes HX90 Installation Manual

LEDS on power-up

Chapter 3 • Installing the satellite router
28
1039456-0001 Revision A
As the router powers up, observe the front panel LEDs to make sure the router is
working properly. When power is applied to the router or after a router reset, the
LEDs light up in the following order, indicating normal power-up:
1. All LEDs light up for ½ sec while the router performs a self-test.
2. The Power LED lights up and remains on, indicating the router is powered up.
3. The Power LED and System LED light up for about 5 to 10 sec while the router
loads and prepares applications.
4. If the router LAN port is connected to a network device, the LAN LED lights up
within 30 sec, indicating that LAN connectivity is detected.
5. The Power LED blinks, indicating that the router is not commissioned.
If the LEDs do not function as described, make sure you have the correct power
supply. Refer to Figure 2 on page 17.