Confirming The Receive Signal - Hughes HX90 User Manual

Confirming the receive signal

Chapter 4 • Troubleshooting
44
1039457-0001 Revision A
The System Information page appears.
Note: The System Info page for your installation may show different fields and
values.
2. In the HX90 section, check the
If the numeric site ID appears, the satellite router is commissioned. Proceed to
Confirming the receive signal on page 44.
If
Not_Commissioned
service provider.
To confirm that the router is properly receiving satellite signals:
1. At the System Control Center, click the
The Reception Information page appears.
2. In the Receive Status field, check the RxCode.
If the RxCode is Receiver operational (RxCode 5) the router is receiving signals
properly; proceed to Confirming the transmit signal on page 45.
Figure 27: System Info page
Site ID
line.
appears, the router is not commissioned. Contact your
Reception Info
link.