Troubleshooting Reference Diagram - Hughes HX90 User Manual

Troubleshooting reference diagram

AC
power
outlet
Surge
protector
Chapter 4 • Troubleshooting
42
1039457-0001 Revision A
CAUTION
When this user guide instructs you to power cycle the router, you should
remove and then re-apply power. If the satellite router uses an AC/DC power
supply, disconnect the AC power cord from the power source (power strip, wall
outlet, or surge protector). If the satellite router uses a DC/DC power supply,
disconnect the DC input cable connector from the router's power supply. In
either case (AC/DC or DC/DC), do not unplug the power cord from the satellite
router's rear panel. Doing so could result in static electricity discharge that could
shock you and/or damage the router.
If you need to use any of the troubleshooting procedures provided in this chapter,
you may find it useful to refer to Figure 26 on page 42. This diagram shows all power
and cable connections for a properly installed HX90 satellite router.
Computer or
Ethernet device
Power
supply
AC
power
cord
This diagram shows an AC/DC power supply. If a
DC/DC power supply is used, the configuration is
similar but does not include a surge protector.
Figure 26: Troubleshooting reference diagram
Ethernet
RESCUE
cable
DC
power
Router
cord
rear panel
Receive
Transmit
To the outdoor
antenna
SWITCH
Do not remove this
plug to power cycle
(remove power from)
the router.
DC IN
S
AT.
IN
S
AT.
OUT