Disarming The System With The Duress Code; Friedland Spectra Plus Lighting; Quick Set; Personal Attack (Pa) Alarm - Response SL5 Installation & Operating Manual

If the system has been triggered the 'ALARM
MEM' LED will flash and the panel will beep
every 10 seconds.
To stop the LED flashing and panel beeping either
a. Press or
ESC
b. Inspect the Event Log to find out the cause
of the alarm.
Note: If the system is Disarmed with the Remote
Control the Siren will beep twice, (unless the warning
beeps have been disabled on the Siren).
DISARMING THE SYSTEM WITH THE
DURESS CODE
If the system is disarmed at the Control Panel using
the Duress Access code the system will Disarm as
normal. However, the Voice Dialler or Remote
Manager dialler will be activated (after the 30s dialler
delay) and the appropriate duress message sent.
The dialler Line LED will not be illuminated during
this call.
FRIEDLAND SPECTRA
If the control panel is liked to a Spectra plus Lighting
Receiver and the Spectra lighting Control is enabled
then any alarm condition (except Fire alarms) will
cause the linked lighting to be switched on for the set
light-on duration.
Stop
00.00 Time
Spectra Enabled Spectra Disabled
Alarm conditions Alarm conditions
will trigger will not trigger
Spectra lighting Spectra lighting
If the spectra lighting is configured as 24-hour then
the lights will be triggered at any time an alarm
occurs. However, if it is configured as time controlled
then the lights will only be triggered if the alarm
occurs either before the programmed stop time or
after the start time. If the alarm occurs between the
stop and start times the lights will not be triggered.
Notes:
1. Spectra lighting signal to be sent (subject to
mode and timed programmed settings) each
PLUS LIGHTING
Start
24.00
Time
Spectra Enabled
Alarm conditions
will trigger
Spectra lighting
time a Tamper or PA switch is triggered and
each time a detector on an enabled zone is
triggered when the panel is armed.
2. Spectra lighting will not be triggered by Smoke
Alarm events.
Spectra Manual-On / Auto switching:
Press switch the linked Spectra lighting ON.
Press to switch the linked Spectra lighting
OFF and back to automatic operation.

QUICK SET

The Quick Set function fully arms the system with a
10s second exit delay:
Press 0
, ?
User Access Code
on the Control Panel.
Alternatively, pressing
period of any armed mode (including Part-Arm 1 and
Part-Arm 2) will reset the remaining exit-delay period
to 5 seconds.

PERSONAL ATTACK (PA) ALARM

An alarm can be immediately triggered at any time
(whether the system is Armed or Disarmed) in the
event of threat or danger by activating a Personal
Attack (PA) switch on either the Remote Control or
the Control Panel as follows:
a. Slide the Personal Attack switch on the
Remote Control upwards, or
b. Press and hold the
approximately 3 seconds on the Control
Panel.
The alarm will continue either for the alarm duration
when the system will automatically reset or until the
system is disarmed.
? ? ? ,
ENTER
0
during the exit-delay
!
9
button for
49