Operating Instructions; Arming The System; Part-Arming The System; Disarming The System - Response SL3 Installation And Operating Manual

OPERATING INSTRUCTIONS

When leaving the premises, the system must be
Armed. However, before doing so, check that all
windows are closed and locked, all protected doors
are closed and PIR Detectors are not obstructed.
Ensure that pets are restricted to areas not
protected by PIR Detectors.
The system has 2 armed modes, ARM and PART-
ARM. The Part-Arm facility allows for selected
zones to be left disarmed whilst the remainder of
the system is Armed.
When the system is Armed (in either mode) the
Zone LEDs for all active zones will illuminate for a
few seconds. Also the appropriate Arming mode
LED will flash. All active zones set as INSTANT will
immediately be Armed and will be able to trigger an
alarm. If enabled, the system exit-delay will start
and the Control Panel will start beeping, (the beep
rate increasing in steps as the delay period expires).
When the exit-delay expires all active zones set to
'Delay' will be Armed and able to trigger an alarm.
By this time the user must have left the property
and closed the final protected door.
If while the system is armed a detector on an
INSTANT zone is triggered then this will
immediately trigger an Alarm with both the Control
Panel and Siren sounding. However, if a detector
on a DELAY zone is triggered, the entry-delay (if
enabled) will start and the Control Panel will start
beeping with the beep rate increasing in steps as
the delay expires. If the system has not been
Disarmed when the entry-delay period expires, the
Alarm will sound. When an Alarm occurs the LED
corresponding to the zone that triggered the alarm
will flash.
At the end of the programmed alarm duration the
Siren and Control Panel alarms will stop and the
system will automatically re-arm itself, (subject to
the conditions of the Zone Lockout feature).
Notes:
– To conserve power and maximise battery life the
PIR detector will only detect movement if there
has been no movement detected within the
previous 2 minutes.
– If the Solar Siren is fitted and the 3 minute limit is
enabled then the siren will stop when the
programmed alarm duration expires or after
3 minutes, whichever occurs first.

ARMING THE SYSTEM

The system can be set in FULL ARM mode using
either the Remote Control or the Control Panel
as follows:
a. Press
,
b. Press
on the Control Panel.

PART-ARMING THE SYSTEM

The system can be set in PART-ARM mode using
either the Remote Control or the Control Panel
as follows:
a. Press
,
b. Press
on the Control Panel.

DISARMING THE SYSTEM

The system can be Disarmed using either the
Remote Control or the Control Panel as follows:
a. Press
,
b. Press
on the Control Panel.
If the system has been triggered, the appropriate
LED will be illuminated to indicate which zone(s)
have triggered the alarm.
Note: If the system is Disarmed with the Remote
Control the Siren will beep twice.
on the Remote Control, or
,
? ? ? ?
ENTER
User Access Code
on the Remote Control, or
,
? ? ? ?
ENTER
User Access Code
on the Remote Control, or
,
? ? ? ?
ENTER
User Access Code
29