Dummy Siren - Response SL5 Installation & Operating Manual

DUMMY SIREN
INSTALLATION
1. Remove the two screws on the battery
compartment cover on the rear of the Dummy
Siren and remove the cover.
2. Insert the 4 batteries ensuring correct polarity
3. Refit the battery cover.
Rear view of Dummy Siren Unit
Mounting Template
On the front face of the Dummy Siren behind the red
lens, you will now notice two red deterrent LEDs
flashing alternately every 5 seconds.
4. Use the clear plastic mounting template to mark
the positions of the four mounting holes shown.
A spirit level placed on the top edge will help
ensure you get the unit level.
5. Undo the fixing screw securing the mounting
plate from the bottom edge of the Dummy Siren
and remove the plate.
24
6. Drill four 6mm holes and fit the wall plugs.
7. Fit the two 30mm fixing screws in the top holes
leaving approximately 9mm of the screw
protruding.
8. Fit the keyhole slots in the top of the Dummy
Siren over these screws and check that they
form a neat fit with minimal movement. If
necessary remove the Dummy Siren and adjust
the screws as required.
9. Remove the Dummy Siren and fit the wall
mounting plate in position using the two 25mm
fixing screws.
10. Fit the Dummy Siren to the wall ensuring that
the keyhole slots are correctly fitted over the
heads of the two top fixing screws and the
lower fixing hole lines up with the wall plate.
11. Secure the Dummy Siren in place by fitting the
lower fixing screw in the wall plate. Do not over
tighten the screw as this could damage the
thread.