Remote Phone Access And Control - Response SL5 Installation & Operating Manual

To stop the LED flashing press
Event Log to read the event message.
To read the event log press
Use and
events. Events are displayed starting with event 1
which is the most recent through to event 99.
Note: The Event Log will not automatically scroll
through the display as before.
Press to return to Standby.
ESC
Event Log Message Structure:
The event log messages are to be structured as
follows. This allows each event to be displayed on
a single screen and not split across two screens.
The top line being the event header detailing the
event number and when the event occurred and the
second line detailing the actual event:
E74: 13/03 14:23
Z12 Smoke LowBat
e.g. Event 74 occurred on 13th March at 2:23pm,
Zone 12 – smoke detector – low battery
Header: 'Enn: DD/MM hh:mm'
Where: nn = event number, 01 through to 99
DD = event date
MM = event month
hh = event hour
mm = event minute
Event Messages:
Zone Event Messages:
Zxx PIR Alarm
Zxx PIR Tamper
Zxx PIR LowBat
Zxx MAG Alarm
Zxx MAG Tamper
Zxx MAG LowBat
Zxx Smoke Alarm
Zxx Smoke Tamper
Zxx Smoke LowBat
or access the
ESC
8
from Standby.
to manually scroll through the
User Event Messages:
User x Arm
User x Disarm
User x PartArm 1
User x PartArm 2
User x Disarm
Master Arm
Master Disarm
Master PartArm 1
Master PartArm 2
Master Disarm
Duress Disarm
System Event Messages:
AC Power Fail
System Low-bat
Remote Low-Bat
Keypad Low-Bat
Panic / PA
System Tamper
RF Jamming
Tel Line Error
V-Dialler Fail
V-Dialler SendOK
R-Manager Fail
REMOTE PHONE ACCESS
AND CONTROL
The Remote Phone Access and Control facility, if
enabled, allows you to dial into the system and
monitor / control the basic alarm system functions.
The Control Panel will answer the call after the set
number of rings and emit 3 beeps on the phone line.
Enter a User Access Code on the telephone keypad.
A valid User Access Code will be acknowledged
with 1 long beep.
An incorrect code will be acknowledged by
2 short beeps.
If a User Access Code is not entered within
30 seconds or is entered incorrectly 3 times
then the Control Panel will automatically
disconnect the line.
51