Alarm Duration; Entry/Exit Delay Period - Response SL5 Installation & Operating Manual

Confirm the new device ID code by sending
the Disarm signal from the same new Remote
Control or Remote Keypad within 15s as
follows...
Press
?
Press
Keypad User Access Code
on the Remote Keypad.
Note: If the confirmation signal is not
received within 15s the control panel will
produce a single long beep and exit the
learning process. The learning process
will need to started again to learn the
new device into memory.
The panel will produce three short beeps and
the LCD will show 'Device
The LCD will then show 'Saving New Device'
while the ID code of the new detector is
stored into memory.
Deleting Linked Devices:
Scroll through the Zone menu until option
Remotes' is displayed. The number of Remote
Controls/Keypads already linked will be shown,
(e.g. if there are two Remotes Controls and one
Remote Keypad linked the display will show
'2.1 Remotes = 3').
To delete all linked Remote Controls and Remote
Keypads press 1
1
Press again within 15s to confirm and
actually delete all devices.
The display will now show
Note: If delete all is not confirmed within
15s then the action will be cancelled and
the Remote Controls / Keypads will not be
deleted and the display will revert to its
original setting.
36
on the Remote Control, or
? ? ?
Confirmed'.
'2.1
.
'2.1 Remotes =
ALARM
Controls the alarm duration of the wireless, internal
control panel and wired sirens in the event of an
alarm, subject to the On / Off status of the wireless
and hard wired sirens which can be independently
controlled and disabled.
,
1
Scroll through the system menu until
Time' (and the
Siren Duration
Default setting: 180 seconds
To change the setting press
Enter the required Alarm Duration in units of
10 seconds (0 - 60).
Press
Press
Note:
to sound until either the system is Disarmed; or
the Alarm Duration time expires. If the
alarm time limit'
Siren will shut down after 3 minutes even if the
Control Panel siren is still sounding.

ENTRY/EXIT DELAY PERIOD

This sets the time entry and exit delay time period for
the system. The exit delay is the period between
0'.
arming the alarm and any detectors being allowed to
initiate an alarm (either instant or delayed). On
entering the property it sets the period between
triggering a detector configured as "delayed" and the
alarm occurring.
Default setting: 30 seconds
Scroll through the system menu until
Delay' (and the
DURATION
current setting) is displayed.
ENTER
e.g. enter 6 for a 60 seconds alarm duration.
minimum setting = 0. (i.e. 0 seconds / no
maximum setting = 60 . (i.e. 600 seconds
to save new setting and exit, or
ENTER
to exit without saving.
ESC
Following an alarm, the Siren will continue
of the Siren is enabled, then the
current setting) is displayed.
'2.2 Alarm
.
alarm).
or 10 minutes).
'3 minute
'2.3 Entry/Exit