Table of Contents
Advertisement
Disarming the System
The system can be disarmed using either the Remote
Control or the Control Panel as follows:
Remote Control:
Press the
button.
The Control Panel will acknowledge the signal by
beeping.
The Siren will also acknowledge the Disarm signal
beeping twice unless beep disable has been set.
Control Panel:
Press the 'Disarm' key, followed by the current User
ccess code followed by the 'Enter' button
?
?
,
User Access Code
The Control Panel will acknowledge the signal by
beeping.
If the system has been triggered and an alarm
condition has occurred, then the appropriate LED
will be illuminated to indicate which zone(s) have
triggered the alarm. Make a note of the zone(s)
indicated to assist in tracing the cause of the alarm,
before pressing to clear the indication and return
the system to Standby.
Personal ttack (P ) larm
full larm condition can be immediately initiated at
any time (whether the system is rmed or Disarmed)
in the event of threat or danger by activating a Panic
Button on either the Remote Control or the Control
Panel.
Remote Control:
Slide the Panic Button upwards.
Control Panel:
Press and hold the
3 seconds.
The alarm will continue either for the alarm duration
when the system will automatically reset or until the
system is Disarmed from the Remote Control or
Control Panel.
?
?
,
9
button for approximately
Tamper
If the battery cover of any device (except a Remote
Control) is removed or if the Solar Siren or Control
Panel are removed from the wall then a Full
condition will be initiated even if the system is
disarmed. The alarm condition will continue either for
the alarm duration when the system will automatically
reset or until the system is Disarmed from the Remote
Control or Control Panel. The Tamper LED on the
Control Panel will flash to indicate the Tamper larm
has been activated.
Note:
The Tamper protection facility on the Solar
Siren operates independently of the Control Panel. If
the Tamper on the Siren is activated this will not be
indicated at the Control Panel.
Battery Monitoring
ll system devices continuously monitor their battery
condition. The Control Panel also monitors the battery
condition of all PIR and Magnetic Detectors. If the
battery level of any device drops below acceptable
levels then its low battery indication will be activated.
In addition if any PIR or Magnetic Contact Detector
has a low battery status it will be indicated on the
'LOW B T' LED on the Control Panel.
LED Glowing
LED Flashing
When a low battery indicator is activated the device
will continue to operate normally for up to 2 weeks
(depending on system use). However, the battery for
that device should be replaced as soon as possible.
Note: Before removing the battery cover on any device
to replace the battery, ensure that the system is put
into Test mode to avoid initiating a Full larm condition.
The low battery indication for each system component
is as follows:
Remote Control:
When the Remote Control is operated under low
battery conditions the transmit LED will continue to
flash after the button has been released.
Under normal battery conditions the LED will extinguish
when the button is released.
25
Magnetic Contact
PIR
larm
Advertisement
Table of Contents
