Latch Key Setup - Response SL5 Installation & Operating Manual

LATCH KEY SETUP

The parameters in this menu configures which
users the Latch Key feature operates with and the
telephone numbers that the system dials when the
Latch Key is activated.
Note: For Latch Key to operate correctly, the
User Access Code, Latch Key Status, User
Status, Latch Key Message and Phone number
must be correctly set and programmed.
Note: To allow the Latch Key to operate before the
system is disarmed, the User Access Code must be
programmed (see page 33).
Scroll through the top level programming menu until
'4. LATCH KEY SETUP'
Note: After completing the
to return to the top level programming menu.
ESC
PROGRAM MODE
Code:
enter Master User Access Code and press ENTER
4.0 Status
xxx
press ENTER
Select
ON->1 OFF->3
is displayed and press
Latch Key Setup press
4. LATCH KEY
SETUP
press ENTER
4.1 User 1 Setup
4.1.1 User 1 4.1.2 Record
Status: xxx User 1 Msg
press ENTER
Select
YES->1 NO->3 YES->1
While recording the
LCD should show...
Recording
Stop->ESC
The recording will
then be replayed.
During replay the LCD
should show...
STATUS
This controls which users the Latch Key facility will
operate with.
Default setting: OFF
Scroll through the Zone menu until
current setting) is displayed.
To change the setting press
Press
Press
LATCH KEY USER SETUP
This configures the individual users that the Latch
Key operates with when set to 'Selected-Users'.
.
ENTER
Default setting: OFF
Scroll through the menu until the required user number
is displayed (e.g.
Users 2 to 6
Structure similar to User 1
xxx
press ENTER
4.1.3 Replay
User 1 Msg
press ENTER press ENTER
Select During replay the LCD
NO->3 should show...
press 1
Playing
Playing
'4.0
.
ENTER
1
to enable Latch Key, or
3
to disable Latch Key.
'4.1 User 1 Setup') and
4.7 Phone No.1
xxxxxxxxxxxxxx
press ENTER
Enter Phone No.1
enter Tel No(32)
press ENTER
Status' (and the
press .
ENTER
4.8 Phone No.1
xxxxxxxxxxxxxx
press ENTER
Enter Phone No.2
enter Tel No(32)
press ENTER
45