System Setup; Learn Remote Controls And Keypads - Response SL5 Installation & Operating Manual

SYSTEM SETUP

The parameters in this menu allow the configuration of
general system parameters, such as Alarm Duration
and control of any hardwired or output relay alarm
contacts. This section also contains the basic setup
information for the systems telephone dialler interface
which must be configured appropriately if any of the
telephone based functionality is to be used.
Refer to System Setup diagram on page 34.
Scroll through the top level programming menu until
'2. SYSTEM SETUP' is
Note: After completing the system setup
to return to the top level programming menu.
Scroll through the menu until
displayed on the LCD and press
After configuring the system parameters press
return to the top level programming menu.
LEARN REMOTE CONTROLS
AND KEYPADS
Allows up to 6 Remote Controls or Remote keypads to
be linked to the system and their ID codes learnt into
memory.
2.1 Remotes = x
Edit->Enter
2.1 Remotes = x
1->Del Learn->3
x = No of remotes/keypads linked
1 = Delete or
3 = Learn
3 = Learn
1 = Delete
Confirm Delete
YES->1 3->NO
press 1 to confirm delete
press 3 to cancel
15s time-out or auto cancel
NO
Delete confirmed
within 15s?
YES
Device Deleted
Wait...
display for 3s
displayed and press
ENTER
press
'2. SYSTEM SETUP'
.
ENTER
Send Disarm
waiting 30s...
6
YES
devices already
linked?
NO
Send Disarm
waiting 30s...
Signal
NO
received within 30s
from Remote/Keypad not
yet linked?
YES
New Device
xxxxxx
display for 3s
Send Part-Arm
waiting 15s...
Remote/Keypad
NO
code confirmed within
15s?
Device Confirmed
xxxxxx
display for 3s
Saving
New Device
display for 3s
Scroll through the Zone menu until option
is displayed. The number of Remote Controls / Keypads
already linked will be shown, (e.g. if there are two
Remotes Controls and one Remote Keypad linked
the display will show
Linking a
the Control Panel:
Note:
Controls / Keypads linked to the Control Panel
then it will not be possible to link any more.
.
Attempting to learn a 7th device will cause the
panel to produce a single long beep and display
ESC
'Cannot
screen for 3s.
is
To learn a new Remote or Keypad ID code and
link it to the selected zone press
to
ESC
The panel will now listen for a valid signal from
a new Remote Control or Keypad.
The Panel will remain in Learn Mode for
30s. If a valid signal is not received from a
new device within 30s it will automatically
exit Learn Mode and return to the top of
level 2.0.
Send DISARM
Remote Keypad as follows...
Press
Press
on the Remote Keypad.
Note: If
to the control panel then the panel will
produce a single long beep and the
received signal from the device will
be ignored.
If the device is new and not already linked to
the system the control panel will produce two
short beeps and the display will show 'New
Device'
(e.g. Remote or Keypad).
'2.1 Remotes =
Remote Control or Remote Keypad to
If there are already 6 Remote
Learn - System Full' message on
from the new Remote Control or
on the Remote Control, or
? ?
Keypad User Access Code
the device is already linked
and the type or the detected
'2.1 Remotes'
3').
3
.
? ? ,
device;
35