Disarming the System
The system can be disarmed using either the Remote
Control or the Control Panel as follows:
Remote Control:
Press the
button.
Control Panel:
Press the 'Disarm' key, followed by the current User
ccess code followed by the 'Enter' button
?
?
,
User Access Code
If the system is disarmed and the ' L RM MEM'
LED is flashing with the panel beeping every few
seconds, this indicates that an alarm condition has
occurred. Use the Event Log to find out and make
a note of where the alarm occurred to assist in
tracing the cause of the alarm.
Quick Set
To operate the quick set function and fully arm the
system in 5 seconds, overriding the programmed exit
delay:-
?
Press
,
User Access Code
Omit Zone
To omit a zone from the next armed session:-
5
?
Press
,
User Access Code
Scroll through the menu until the required zone is
displayed. The current setting will also be displayed.
To change the setting press
1
Press
to omit the zone, (i.e. zone omit ON).
3
Press
to re-enable the zone, (i.e. zone omit
OFF).
fter configuring zones to be ommited as required
press
to return to Standby mode.
ESC
Note: Omitting a zone will only affect the next armed
session. When the system is disarmed the omitted
zones will be re-enabled ready for the next armed
session.
?
?
,
?
?
?
,
?
?
?
,
.
Personal ttack (P ) larm
full larm condition can be immediately initiated at
any time (whether the system is rmed or Disarmed)
in the event of threat or danger by activating a Panic
Button on either the Remote Control or the Control
Panel.
Remote Control:
Slide the Panic Button on the side of the Remote
Control upwards.
Control Panel:
Press and hold the
3 seconds.
The alarm will continue either for the alarm duration
when the system will automatically reset or until the
system is disarmed.
Tamper
If the battery cover of any device is removed or if the
Siren or Control Panel are removed from the wall then
a Full
larm condition will be initiated even if the
system is Disarmed. The alarm condition will continue
either for the alarm duration when the system will
automatically reset or until the system is Disarmed.
The ' L RM MEM' LED on the Control Panel will
flash and the panel will beep every few seconds to
indicate an alarm has occurred.
Note: The Tamper protection facility on the Siren
operates independently of the Control Panel. If the
Tamper on the Siren is activated this will not be
indicated at the Control Panel.
Chime
The Chime facility can only be operated with the
system in Standby mode.
2
Press
to toggle the Chime facility between ON
and OFF.
Note: If the Chime is ON and the system is then
armed the Chime will remain ON after the system is
disarmed.
Event -Log
The Event Log will store the last 50 system
disarm, alarm and detector Low Battery events. The
Event Log will record the time, date and detail for
each event.
36
9
button for approximately
rm,