Linkinga Remote Control Or Remote Keypad To The Control Panel - Response SL5 Installation & Operating Manual

7. Ensure that the Reset Jumper Link (P1) and the
External Tamper Switch Jumper Link (P51) are
set in the OFF position.
Jumper
Link
External Tamper Switch
Jumper Link P51
Jumper
Link
8. Connect battery leads to both back-up batteries
and refit batteries.
LEFT Battery: Red lead to the Red (
terminal
Black lead to the Black
terminal
RIGHT Battery: Red lead to the Red (
terminal
Black lead to the Black
terminal
IMPORTANT: Take care when connecting
battery leads to the batteries as connecting
incorrectly could damage the batteries or the
Control Panel.
Note: The Power LED may flash to indicate that
the unit is being operated from the back-up
batteries and that mains supply is not present.
9. If fitted, remove the plastic film covering the LCD
display and on the display window on the cover.
10. Close the lid of the Control Panel and fasten the
cover fixing screws.
11. Plug in and switch ON the Power Supply
Adaptor, (the Power LED should illuminate).
12. If required, connect the Control Panel to the
telephone line using the cable supplied by
12
Jumper
Link
Reset Jumper
Link P1
OFF ON
+ ) battery
(-)
+ ) battery
(-)
inserting the small RJ11 plug into socket marked
LINE located on the bottom edge of the Control
Panel. If the cable supplied is not long enough
to reach a suitable phone point then it will need
extending using a coupler and extension lead
(not supplied).
Note: If
during the installation reset the alarm by pressing
,
IMPORTANT: The keys must be pressed firmly
and within 5 seconds of each other. If you make
a mistake, press
LINKING
REMOTE KEYPAD TO THE
CONTROL PANEL
If there are already 6 Remote Controls/Keypads
linked to the Control Panel then it will not be possible
to link any more. Attempting to learn a 7th device
battery
will cause the panel to produce a single long beep
and display
on screen for 3 seconds.
With unit in Standby mode (Power LED only
battery
illuminated).
1. Press
This puts the Control Panel into Programming
Mode.
'1. USER SETUP'
2. Use the
the menu until
and press
3. Press
The number of Remote Controls/Keypads
already linked will be shown, (e.g. if there are
two Remotes Controls and one Remote Keypad
linked the display will show
The new Remote Control/Keypad can be programmed
as follows:
4. Press
the Control Panel Tamper alarm sounds
1 2 3 4
,
ENTER
User Access Code
and start the sequence again.
ESC
A REMOTE CONTROL OR
'Cannot Learn - System Full' message
1 2 3
,
Master User Access Code
will be displayed.
and buttons to scroll through
'2. SYSTEM SETUP'
. '2-1 Remotes'
ENTER
again.
ENTER
3
.
on the Control
Panel.
4
,
ENTER
is displayed
will be displayed.
'2.1 Remotes = 3').