Operating Instructions; Voice Dialler; Arming The System; Part-Arming The System: Part-Arm - Response SL5 Installation & Operating Manual

OPERATING INSTRUCTIONS

When leaving the premises, the system must be Armed.
However, before doing so, check that all windows are
closed and locked, all protected doors are closed and
PIR Detectors are not obstructed. Ensure that pets are
restricted to areas not protected by PIR Detectors.
The system has 3 arming modes, ARM, Part-Arm 1
and Part-Arm 2. The Part-Arm modes allow for
selected zones to be left in a Disarmed state whilst
the remainder of the system is Armed.
When the system is Armed the mode being activated
will be displayed on the screen followed by the status
of the Latch Key feature. The programmed system
exit-delay will be displayed and counted down on the
screen. If exit-delay beeps are enabled the panel
will beep with the beep rate increasing in steps as
the exit-delay expires. At the end of the Exit period
all active zones will be fully Armed. By this time the
user must have left the property and closed the final
protected door.
If while the system is armed a detector on an active
zone is triggered the programmed entry-delay for
that zone will be displayed and counted down on the
screen. If entry-delay beeps are enabled the panel
will beep with the beep rate increasing in steps as
the entry-delay expires. If the system has not been
Disarmed when the entry-delay expires a Full Alarm
will occur. (Note: if the entry-delay for the zone
triggering the alarm is disabled then an alarm will
occur immediately the detector is triggered instead).
Details of the zone event that triggered the alarm will
be recorded in the Event Log.
At the end of the set alarm duration the Siren and
Control Panel alarms will stop and the system will
automatically re-Arm itself, (subject to the conditions
of the Zone Lockout feature).
Notes:
– To conserve power and maximise battery life the
PIR detector will only detect movement if there
has been no movement detected within the
previous 2 minutes.
– If the Solar Siren is fitted and the 3 minute limit is
enabled then the siren will stop when the
programmed alarm duration expires or after 3
minutes, whichever occurs first.
48
ARMING THE SYSTEM
The system can be set in FULL ARM mode using
either the Remote Control or the Control Panel as
follows:
a. Press
b. Press
,
on the Control Panel.
PART-ARMING THE SYSTEM:
PART-ARM 1
The system can be set in PART-ARM 1 mode using
either the Remote Control or the Control Panel as
follows:
a. Press
b. Press ,
on the Control Panel.
PART-ARMING THE SYSTEM:
PART-ARM 2
The system can be set in PART-ARM 2 mode using
either the Remote Control or the Control Panel as
follows:
a. Press
Control, or
b. Press
on the Control Panel.
DISARMING THE SYSTEM
The system can be Disarmed using either the
Remote Control or the Control Panel as follows:
a. Press
b. Press ,
on the Control Panel.
on the Remote Control, or
,
? ? ? ?
ENTER
User Access Code
on the Remote Control, or
? ? ? ? ,
ENTER
User Access Code
, on the Remote
, ? ? ? ?
User Access Code
on the Remote Control, or
? ? ? ? ,
ENTER
User Access Code
,
ENTER