Table of Contents
Advertisement
3.2 Powering up the system
Insert the memory card into the DVR if not already fitted
Press and Hold power key for one second to power hold the power. Press and hold the power
key for two seconds to power off the system.
After system power on, adjust the camera viewing position again if necessary.
Trouble Shooting
PROBLEM
No camera picture
Poor picture quality
A white image
appears at night
The system will
not record under
SCHEDULE/
MOTION detection setting
Micro SD card slot
on 7" LCD DVR
The 7" LCD monitor DVR is fitted with a rechargeable battery and
can operate for up to 4 hours (in power save mode) on battery power
once fully charged. The monitor can be carried around anywhere
within operating range of the cameras, but should be used in a dry
environment as it is not weatherproof.
SOLUTION
The power supply adaptor for the monitor
camera(s) is not plugged in.Camera out
of range. Locate camera closer to the
receiver.
Clean the camera lens.
The camera's infra-red LEDs shine
invisible light that reflects of surfaces such
as glass causing white light. Place the
camera on the other side of windows to
try to improve the night vision or place in a
well lit area.
Ensure correct DATE AND TIME has
been set and the Record Schedule setup
correctly.
Ensure the memory card is inserted into
DVR and formatted.
9
ON/OFF
power button
Advertisement
Table of Contents
