Power-Up Of The Solar Siren - Response SL5 Installation & Operating Manual

Siren
Tamper
Switch
Learn
LED
Learn
Switch
9 Volt startup
battery
6 Volt 1.2Ah
rechargeable
battery
5. DIP switch 2 marked "AJ"
this system and should be ignored.
6. DIP switch 3 marked "ALARM SOUND"
will prevent the siren from sounding during an
alarm, (this will not affect the warning beeps):
ON Siren enabled
OFF Siren disabled
7. Switching between Service Mode and Operating
Mode generates a series of beeps. It is possible
to disable these acknowledgement beeps with
DIP switch 4 marked
ON Beeps enabled
OFF Beeps disabled
8. Now see Power-Up of the Solar Siren.

POWER-UP OF THE SOLAR SIREN

Note: The use of ear defenders is advisable when
working in close proximity to the Siren due to the high
sound level produced by this device when triggered.
Whenever the Siren is powered-up, it will automatically
power-up in Service Mode. It cannot be switched out
of Service Mode and into Operating Mode until the
Control Panel is linked to it.
9. Connect the rechargeable battery to the battery
leads. Connect the Red lead to the Red (+ve)
terminal and the Black lead to the Black (-ve)
terminal.
Connect the 9V 6LR61 (PP3) power-up battery
to the battery clip.
22
ON
1 2 3 4 5
does not function
if OFF
"BEEP SOUND".
ALARM TIME
ALARM SOUND
BEEP SOUND
C.U. OR SIREN
7.5 Volt DC
charging
adaptor input
Wall mounting plate
for 10. Press the tamper switch, both indicator LEDs will
flash together several times. The LEDs will then
continue to flash alternately every 5 seconds
thereafter to indicate that the Siren is functioning
(still in Service Mode).
11. If fitted remove the protective film covering the
Solar Panel.
12. Press and hold the Learn button inside the
Sirens battery compartment for 5 seconds until
the Siren enters Learn Mode and produces a
single short low volume beep and both Learn and
Indicator-LEDs start flashing together slowly
(once every 2 seconds).
The siren will remain in Learn Mode for 30s. If a
valid signal is not received from a Control Panel
within that period it will automatically exit Learn
Mode. It will remain in Service mode.
13. Use the
the menu until
displayed.
14. Press
The LCD will display
15s...' for 15s.
After 2 seconds the 'Siren Stop'
transmitted by the panel to the siren to learn the
panel's code.
The siren will produce a single short beep and
Switch SW3
A J
and buttons to scroll through
'Link Panel to Wirefree Siren'
.
ENTER
'Sending ID Codes
ALARM TIME
A J
ALARM SOUND
BEEP SOUND
C.U. OR SIREN
is
wait
signal will be