Voice Memo; Replay Messages; Remote System Control - Response SA5 E Installation And Operating Instructions Manual

If when the system is disarmed the ' L RM MEM' LED
is flashing and the panel beeps every 10 seconds, this
indicates that an alarm has occurred. To cancel the LED
and stop the beeping you must access the event log.
To access the Event Log, (with the system in Standby):
8
Press .
The Event-Log will automatically start scrolling
through and displaying the event data starting with
the most recent event. The data for each event is
shown on two screens, each screen will be displayed
for 5 seconds before moving on to the next screen
and then the next event.
Use the and
through the event log to the required position as
necessary.
Press to return to standby.
ESC

Voice Memo

To record a message, (max. duration 30s), at the
Control Panel using the Voice Memo facility, proceed
as follows:
1
Press
Press to start recording
While recording, press
and skip the remaining message time.
If there are already 6 messages recorded it will not be
possible to record a voice-memo message until a
message has been deleted.
The Voice Memo message may be accessed either at
the Control Panel (see Replay Messages) or via the
Remote System Control facility.

Replay Messages

If the 'MESS GE' LED is illuminated, this indicates
that either a new nswer-Phone or Voice-Memo
message has been recorded and has not been read.
The recorded messages may be accessed at the
Control Panel as follows:
4 ?
Press
,
Messages are replayed in order starting with the
most recent. Press
the message.
buttons to manually scroll
to stop the recorder
ESC
? ? ?
,
User Access Code
to skip to the end of
ESC
t the end of each message there will the option of
deleting the message just heard.
To delete the message
1
Press to delete the message
1
Press to re-confirm and actually delete the
message.
3
Note: Press
and move on to the next message.
fter all messages have been replayed the system
will automatically return to Standby Mode.

Remote System Control

If the Remote System Control facility is enabled, the
control Panel will answer the call after the set number
of rings and emit three beeps on the phone line to
prompt for a User ccess code to be entered using
the telephone keypad.
valid User ccess code will be acknowledged
with one long beep.
acknowledged by two short beeps.
If the User ccess code is not entered within 30s or
is entered incorrectly three times then the Control
Panel will automatically hang-up the line.
Note: If the internal
and there is space for a new message then the call
will be answered with the
message. The User ccess code should be entered
during the greeting message, otherwise the answer-
phone message recorder will be activated.
Use with an External nswer-Phone:
If the Remote System Control is to be used in
conjunction with an external nswer-Phone then
1. The internal nswer-Phone must be disabled.
2. The number of 'rings to answer' for the
Control Panel must be greater than that of
the External
Control Panel will always pickup the call
before the nswer-Phone.
To access the Remote System Control facility the
Control panel has a 'double dial-in' feature to
enable the Control Panel to pick-up the phone
call before the external
The 'double dial-in' procedure is as follows:
37
at either stage to cancel delete
n incorrect code will be
nswer-Phone is also enabled
nswer-Phone greeting
nswer-Phone, otherwise the
nswer-Phone cuts in.