Setting The Control Panel House Code; Testing The Control Panel And Remote Control; Remote Control Unit - Response SA5 E Installation And Operating Instructions Manual

Note: If the Panel Tamper alarm sounds during the
installation reset the alarm by pressing:
1 2 3
,
on the Control Panel Keypad.
Setting the Control Panel
House Code
With the unit in Standby mode (Power LED only
illuminated).
1
1. Press
,
to put the system into Programming mode.
'1. USER SETUP' will be displayed.
2. Use the and
the menu until '2. SYSTEM SETUP' is displayed.
Press and '2-1 Learn House Code' will be
displayed.
Press again to set the Control Panel to receive
the House code. 'DIP SW 12345678 & H Code:
xxxxxxxx' will be displayed.
3. With the required House Code already configured
on the Remote Control, press
on the Remote Control.
When the Control Panel receives the signal from
the Remote Control the Display will change to
show the received house code on lower line of
the display beneath the corresponding DIP switch
numbers (1-8).
4. Press
ESC
,
to return to Standby mode.
Testing the Control Panel and
Remote Control
1
1. Press
,
to put the system into Test mode.
'TEST MODE – W LK TEST' will be displayed.
2. Press to activate Walk Test.
'Walk Test Waiting...' will be displayed.
3. Press the ' RM' button on the Remote Control.
s the key is pressed the Control Panel will beep
and the type of the device and button will be
shown on the display.
4
,
2 3 4
,
buttons to scroll through
the button
ESC
,
2 3 4
,
Press the other buttons on the Remote Control in
turn, as each button is pressed the Control Panel
will beep and show the button being pressed on
the display.
4. Test the range of the Remote Control by pressing
the 'DIS RM' button on the Remote Control from
in and around the property and from all locations
where you plan to install detectors. Check that
the Control Panel acknowledges the signal from
the Remote Control each time the 'DIS RM'
button is pressed.
5. Press to return to the top level menu of
ESC
TEST MODE.

Remote Control Unit

The Remote Control Unit is used to rm, Part- rm and
Disarm the system.
Arm
Part-Arm
Disarm
The Remote Control Unit also incorporates a Panic
switch. ctivating the Panic switch on the side of the
Remote Control will immediately initiate a Full
condition whether the system is rmed or Disarmed.
The alarm can be cancelled by pressing the 'DIS RM'
button on the Remote Control or via the Control Panel.
ny number of Remote Control Units can be used with
your system, providing they are all coded with the
same system House Code.
The Remote Control uses a CR2032 type Lithium cell
which under normal conditions will have a typical life
in excess of 1 year. Under normal battery conditions
the LED on the Remote control will illuminate only
when a button is pressed.
battery conditions this LED will flash every time the
button is pressed.
should be replaced as soon as possible.
10
Transmit LED
Slide up
to operate
Personal
Attack
However, under low-
When this occurs the battery
larm