Walk Test; Larm Test; Wirefree Siren Service On/Off; Voice Dialler Test - Response SA5 E Installation And Operating Instructions Manual

Use the and
menu and press
function or sub-menu.
Note: fter completing all required test functions
press to leave Test mode and return to Standby.
ESC

Walk Test

Before commencing testing please ensure that there
is no movement in any PIR protected area, all
doors/windows protected by Magnetic Contact
Detectors are closed and that all battery covers and
housings are correctly fitted.
Scroll through the top level Test Mode menu until
'W LK TEST' is displayed and press
'Walk Test Waiting...' will be displayed.
1. Trigger each detector on the system by either
walking into a PIR protected area or by opening a
door/window protected by a Magnetic Contact
detector. s each detector is triggered the Control
Panel will beep to indicate that an alarm signal has
been received and the identity of the zone that the
detector is configured for will be displayed
2. Operate detector anti-tamper switches by
opening the case of the device.
are operated the Control Panel will beep and
' ccessory Tamper' will be displayed.
3. ctivate each button on the Remote control in
turn. s each button is pressed the Control panel
will beep and the button name will be displayed,
(e.g. 'REMOTE CONTROL DIS RM').
Press to exit Walk Test and return to the top
ESC
level Test Mode menu.

larm Test

Scroll through the top level Test Mode menu until
' L RM TEST' is displayed and press
Scroll through the menu until the required alarm is
displayed and press
alarm for 5 seconds.
Select 'Wirefree Siren Test' to operate the External
Solar Siren.
Select 'Hardwired Siren Test' to operate the Control
Panel Siren and external hardwired Siren (if connected).
buttons to scroll through the
to select the displayed test
.
s the switches
.
to operate the selected
Select 'Relay Test' to operate the External hardwired
(N.O./N.C.) Relay contacts.
Press to exit larm Test and return to the top
ESC
level Test Mode menu.

Wirefree Siren Service ON/OFF

Scroll through the top level Test Mode menu until
'Wirefree Siren Service ON/OFF' is displayed and
press .
This offers the flexibility of removing or changing
siren's battery. Wait for 10 seconds until ON / OFF
duration has elapsed, then go ahead with fixing the
siren as desired.

Voice Dialler Test

Scroll through the top level Test Mode menu until
'VOICE DI LLER TEST' is displayed and press
In order to test the voice dialler properly, the
prerequisite is to set the telephone number, record
the message and enable the call routing in the
programming mode.
When testing is in progress, simply press
stop testing.
If 'LINE ST TUS' LED is flashing, it implies bad
telephone line connection or telephone network
being out of order. Check the telephone line and re-
test it.

Digital Dialler Test

Scroll through the top level Test Mode menu until
'DIGIT L DI LLER TEST' is displayed and press
In order to test the digital dialler properly, the
prerequisite is to set the telephone number and unit
ID number in the programming mode.
When testing is in progress, simply press
stop testing.
If 'LINE ST TUS' LED is flashing, it implies two causes
of failure. One is bad telephone line connection or
telephone network being out of order.
The other cause of failure is derived from the central
monitoring station. Consult with the central monitoring
station for help.
19
.
to
ESC
.
to
ESC