Omit Zone; Zone Lockout; Event Log; Chime - Response SA5 E Installation And Operating Instructions Manual

system is armed and a zone configured as a 'Master
Walk Through' zone is triggered, the zones Entry-
Delay will start. ny zones configured as 'Slave Walk
Through' will be disabled to allow free access to the
Control Panel to disarm the system before the Entry-
Delay expires an alarm occurs.
If access is gained via a zone that is not configured as
'Master Walk Through', the 'Slave Walk Through' zones
will operate as normal according to their programmed
Entry-Delay setting.
Note: zone set as a 'Master Walk Through' zone
must be configured with an Entry-Delay.

Omit Zone

zone may be temporarily omitted when the system
is armed using the Omit feature. When the system is
next disarmed any zones set to Omit will be cancelled.

Zone Lockout

If a detector on an active zone is triggered while the
system is armed an alarm condition will occur.
the programmed alarm duration has expired the alarm
will stop and the system will automatically reset.
Subsequent detectors triggered will again initiate an
alarm condition. If a single zone initiates an alarm
condition more than three times then that zone will be
'Locked Out' and any further alarm signals from that
zone will be ignored until the system is disarmed.
Note: The 'Zone Lockout' feature can be disabled
if required.

Event Log

The Control Panel incorporates a memory capable of
storing the last 50 system events. This enables the
user to see which user has
system and if and when any alarms occurred. The
time, date and details of the event type will be
recorded for each system event.

Chime

Chime is a low security facility for use when the
system is in Standby mode. If the Chime feature is
ON, and a detector on a zone that has its Chime
function enabled is triggered, the internal sounder
will produce a low volume warning tone.
use of the Chime function would be to warn that a
door or particular area has been accessed.
fter
rmed/Disarmed the
typical
5

Voice Dialler

If the Voice Dialler is enabled and an alarm condition
occurs, the system will call for help using your recorded
alarm messages and up to four telephone numbers.
When an alarm condition occurs, the telephone voice
dialler (if enabled) will call the first enabled number in
the calling sequence and replay the recorded alarm
messages for the configured 'Play Time'. The recipient
must acknowledge the message by pressing the
button on their telephone keypad. If the call is
unanswered or an acknowledgment is not received
then the next active number in the dialing sequence
will be called. The dialler will continue calling each
number in turn until either all numbers in the sequence
have been dialed the set number of times or the
sequence is cancelled/acknowledged by the recipient.

Digital Dialler

s an alternative to the Voice dialler the system may be
configured to interface with a central monitoring station.

Latch Key

When the system is disarmed the Latch-Key
facility, if enabled, will call the first latchkey phone
number and replay the user message (recorded
under user setup) for the set 'Play Time'. The recipient
must acknowledge the message by pressing the
button on the telephone keypad. If the call is
unanswered or an acknowledgment is not received
then the second latchkey phone number will be called.
The voice dialler will continue calling each number in
turn until each number has been dialed the set number
of times or the sequence is cancelled/acknowledged
by the recipient.
For example, the latchkey facility is useful to inform
parents that a child has returned from school and
disarmed the system.

nswerphone

The Control Panel includes an answer-phone facility.
The answerphone will record and store a maximum
of 6 messages with each message being limited to a
30 seconds duration.
Messages may be retrieved either direct from the
Control Panel or by dialing into the system from a phone.