Part- Rm 2 Setup; Time & Date Setup - Response SA5 E Installation And Operating Instructions Manual

Part- rm 2 Setup

7-1 EXIT Delay
xxx xxxs
7-1-1 Status 7-1-2 Delay Time
xxx Enter (10-250s)
Select Enter (10-250s)
ON->1 OFF->3
Scroll through the programming menu until '7. P RT-
RM 2 SETUP' is displayed and press
Note: fter configuring Full rm press
to the top level programming menu.
Exit Delay
Scroll through the menu until '7-1 EXIT-DEL Y' is
displayed. The current settings will also be displayed.
To change the settings press
On/Off Status
Default setting: ON
Scroll through the menu until '7-1-1 Status' is
displayed. The current setting will also be displayed.
To change the settings press
1
Press to enable the Exit delay, or
3
Press to disable the Exit delay.
Delay Period
Default setting: 30 seconds
Scroll through the menu until '7-1-2 Delay Time' is
displayed. The current settings will also be displayed.
To change the settings press
Enter the required delay period (10 to 250s).
Press to save and exit, or
Press to exit without saving.
ESC
Press to return to top level Part- rm 2 Setup
ESC
menu.
PROGRAM MODE
Code:
7. PART ARM 2
SETUP
7-2 Entry Delay 7-3 Exit Delay
Beep: xxx Beep: xxx
Select Select
ON->1 OFF->3 ON->1
.
to return
ESC
.
.
.
Entry Delay Beep
This controls the warning beep which operates during
the Entry Delay period when Part- rm 2 is active.
Default Setting: ON
Scroll through the menu until '7-2 Entry Delay Beep' is
displayed. The current setting will also be displayed.
To change the setting press
OFF->3
1
Press
3
Press
Exit Delay Beep
This controls the warning beep which operates during
the Exit Delay period when Part- rm 2 is initiated.
Default Setting: ON
Scroll through the menu until '7-3 Exit Delay Beep' is
displayed. The current setting will also be displayed.
To change the setting press
1
Press
3
Press
Time & Date Setup
Scroll through the menu until '8 TIME & D TE SETUP'
is displayed and press
Note: fter configuring the Time and Date press
to return to the top level programming menu.
Date
Scroll through the menu until '8-1 Date' is displayed.
The current setting will also be displayed.
To change the setting press
Enter the date in the format 'dd/mm/yy'.
Press
Press
ESC
32
.
to enable the entry-delay beep, or
to disable the entry-delay beep.
.
to enable the exit-delay beep, or
to disable the exit-delay beep.
PROGRAM MODE
Code:
8. TIME & DATE
SETUP
8-1 Date 8-2 Time
DD/MM/YY DDD HH/MM/SS
DD/MM/YY HH/MM/SS
.
.
to save and exit, or
to exit without saving.
ESC