Exhaust Valve Control Cable Adjustment - Suzuki RG250 Service Manual

ADJUSTMENT
• After mounting the engine, route wiring harness
tloses and cables properly by referring to the
sections for wire routing, hose routing and cable
~outing. and adjust the following items to the
specifications.
• Exhaust valve control cable
• Align the index line Q) on the actuator body
with the mark
®
on the pulley by turning the
pulley.
• Connett the each exhaust valve control cable to
the respective positions of the actuator.
• No. 1 cable is connected to "1" position of the
actuator.
NOTE :
The exhaust valves should be in open position
when connecting the cables. (Refer to page
3·44.)
• After connecting all cables to the actuator,
adjust the cable play to 0.5 mm by turning the
adjuster.
Cable play
0.5 mm
Page
" Throttle cable play ....••..•..•••..... 2- 7
.. Clutch cable play ... . .....•.......... 2-10
Drive chain play ..................... 2-12
.. Engine idle r/min ......•.•••.••.•.... 2- 8
.. Oil pump cable play .......•• . ........ 2-10
.. Transmission oil ..................... 2-11
.. Coolant ...............•••.• • •.... . 2- 9
.. Oil pump air bleeding ......••. , . , ..... 5- 7
ENGINE 3·10