Setup And Activate Your Cubepro - 3D Systems CubePro User Manual

SETUP AND ACTIVATE YOUR CUBEPRO

1 . Select your language . Press the
2 . Enter a name for your printer . Scroll to the letters you wish to select by pressing
the arrow symbols on each side of the screen . Press the letters to select them .
Select the checkmark
press SKIP to move to the next screen and continue with step 4 .
3 . Connect your printer to your wireless network . Use the up or down arrow to scroll
to your network choice . Select the
NOTE: If your network is password protected, the printer will first
prompt you to enter the password .
NOTE: The printer can also connect to an ad hoc network, a
decentralized network that wirelessly connects a local computer
to the printer directly . The computer must have a wireless adapter
configured for ad-hoc mode. The adapter must use the same SSID as
is found in the printer . Connecting to an ad hoc network is discussed
further in the section titled
3D Systems, Inc.
checkmark to confirm your selection.
to continue . If you do not wish to name your CubePro,
checkmark to continue .
Setting Up an Ad Hoc Network .
14