3D Systems CubePro User Manual page 79

Prosumer 3d printer

Hide thumbs Also See for CubePro:

Table of Contents

2 .

Select the

checkmark

3 .

Select the print jet you wish to test .

4 .

Select the target temperature value twice to read 260°C .

NOTE: To increase or decrease the temperature value, press the up

or down arrow .

NOTE: The typical printing temperature for ABS print material is

260°C . The typical printing temperature for PLA material is 220°C .

For best results, leave the default target temperature at 260°C while

extruding print material from the Control Jets test utility .

NOTE: The current temperature reading will appear above the

target temperature value .

5 .

Once the temperature has reached 260°C, select the speed value .

NOTE: Pressing the speed value twice will place the value at 4 .0

RPM . Press the up or down arrows to increase or decrease the

extrusion speed .

6 .

Once you have finished, reduce the target speed to 0.0 RPM and the target

temperature to 0 .0°C . You can now select the next print jet and follow this

procedure if necessary .

NOTE: Pressing the values twice for target temperature and speed

should change the values to 0 .0 .

For further troubleshooting, contact Cubify Support at Cubifysupport@cubify .com .

3D Systems, Inc.

to continue .

Table of Contents

Show Quick Links

Table of Contents