Printing The Level Gap Calibration File - 3D Systems CubePro User Manual

Printing the Level Gap Calibration File

NOTE: Ensure the print pad is completely clean from glue and printed parts before beginning this procedure .
1 . Download the Level Gap Calibration file from
mass storage device .
2 . Insert the USB mass storage device into the USB host port .
3 . Select PRINT .
4 . Using the arrows, navigate to the Level Gap Calibration file and select PRINT .
5 . Apply two thin layers of Cube Glue to the print pad in an area of 50 mm x 50
checkmark
mm . Select the
NOTE: For more information, refer to the section titled
Cube Glue .
NOTE: It may take several minutes to print the file.
6 . When finished, remove the print pad and verify the Level Gap.
NOTE: Refer to the sections titled
Print and Reading The Print Pad Level Calibration
NOTE: If any adjustments are needed, perform this procedure again
after making the adjustments . Make sure all glue and plastic residue
have been removed prior to performing this procedure again .
3D Systems, Inc.
www .Cubify .com
to continue .
Reading The Z-Gap Calibration
to your USB
Applying
Print .
65