Replace Fuses - 3D Systems CubePro User Manual

4 . Press and release the touchscreen display
restart .

REPLACE FUSES

The printer has two (2) fuses that are designed to provide moderate circuit protection . If the fuses become defective, refer to the
following procedure to replace the fuses .
Caution: Double Pole/Neutral Fusing .
1 . Power off the printer and disconnect the power cord from the printer .
2 . Open the fuse door above the main power switch .
3 . Remove the fuse cartridge from the power inlet housing .
4 . Remove the defective fuses and install new ones .
Caution: Ensure the replacement fuses are rated correctly .
NOTE: Fuse: 5x20mm T10A L 250V .
3D Systems, Inc.
ON/OFF button and the display will
81