Setting Up An Ad Hoc Network - 3D Systems CubePro User Manual

SETTING UP AN AD HOC NETWORK

NOTE: An ad hoc wireless network can not be created in Windows® XP .
An ad hoc network is a temporary yet direct connection between a computer or device and the printer . It does not connect through
a router or base station and the data transfer rates are slower than the transfer rate of standard wireless networks . The computer or
device you wish to connect ad hoc to the printer must have an ad hoc adapter installed . An ad hoc network is deleted when the user
has disconnected from it or is out of range of other devices on the network unless it has been made a permanent network .
SETUP
1 . Select from the home screen .
2 . Using either the left or right the navigation arrows, navigate to the
screen .
3 . Select WIFI .
4 . Select ADHOC from the Select WIFI Connection Type screen .
ON/OFF
5 . Select the bar to turn on the ad hoc network connection .
3D Systems, Inc.
Network
57