Initial Setup Of The Cube - 3D Systems cube User Manual

INITIAL SETUP OF THE CUBE

1 . Select your language . Select the
NOTE: The selected language will be indicated .
2 . Enter a name for your printer . Scroll through the letters by pressing the arrow
symbols on each side of the screen . Select the letters to spell out the name .
Select the checkmark
NOTE: You can name your printer at any time . Navigate to the
System 1 screen, select CUBE NAME and follow the instructions on
the touchscreen display .
NOTE: Selecting the
uppercase letters and numerals .
3 . Connect the printer to a network . Use the up or down arrows to scroll to your
network choice . Select the desired network name . Select
step .
NOTE: You can connect to a wireless network at any time . Navigate
to the Network screen, select WIFI and follow the prompts on the
touchscreen display .
NOTE: The printer can also connect to an ad hoc network, a
decentralized network that wirelessly connects a local computer
to the printer directly . The computer must have a wireless adapter
configured for ad hoc mode. The adapter must use the same
SSID as is found in the printer . Connecting to an ad hoc network
is discussed further in the section titled
Network .
NOTE: The printer will attempt to connect to your network .
3D Systems, Inc.
checkmark to continue .
to confirm your choice. Select
abc button toggles between lowercase letters,
Setting Up an Ad Hoc
SKIP to bypass this step .
SKIP
to bypass this
12