3D Systems CubePro User Manual page 39

12 . Rinse the tank and refill it with 0.75 liters of water.
13 . Using plastic tongs, place the model back into the tank .
14 . Once all of the caustic soda has been cleaned from the area, you may remove your personal protection equipment .
15 . Repeat the ultrasonic process with clean water for 30 minutes at 60°C to remove any caustic soda residue that may remain on the
model .
16 . Once the ultrasonic process has completed the second time, use plastic tongs to remove the model from the ultrasonic tank .
17 . Rinse it under cold water for 1 to 2 minutes .
3D Systems, Inc. 35