3D Systems CubePro User Manual page 76

5 . Insert the mass storage device into the CubePro USB inlet port and select
PRINT .
6 . Navigate to the calibration file and select PRINT .
NOTE: The filename may differ from the illustration.
NOTE: The printer may require you to install additional cartridges
or replace a cartridge . Follow the instructions on the screen and
refer to the section titled
7 . Once the printer has finished printing, remove the print pad from the printer and
inspect the scales . If adjustments are required, proceed to the next step . If the
scales are aligned properly, no further action is required .
Print Jet Calibration
8 . Navigate to the
9 . Since the file has already been printed, select the
3D Systems, Inc.
Unpacking and Setting Up Your
OFFSET
screen and select
checkmark
CubePro .
JETS .
to continue .
72