3D Systems CubePro User Manual page 26

8 . (1) Push the front of the cartridge into place . (2) Then, push the cartridge
handle downward until the cartridge is fully seated in its mount . Select the
checkmark to continue .
NOTE: Ensure the front of the cartridge (A) where the material exits
is seated under the clamp roller and between the vertical alignment
pins in the cartridge bay .
CAUTION: If replacing the third cartridge, be sure to rotate the
second bay cartridge to its vertical position before selecting the
checkmark .
NOTE: The print pad must be calibrated before printing your first
creation . For more information, refer to the following section titled
Calibrate Print Pad .
3D Systems, Inc.
A
22
2
1