3D Systems CubePro User Manual page 16

11 . Open the front door . Cut away the zip ties (A) and remove the foam tubing from
the print jet area .
12 . Loosen and remove the four (4) 4mm screws securing the Z-Axis guard and
remove the guard . Save the guard and screws for future repacking .
13 . Using a 4mm hex head driver, attach the mounting posts to the jet wiper
assembly with the supplied screws and washers .
NOTE: Tighten the screws until the posts are secure .
14 . Move the jet wiper assembly to the back of the printer and locate the keyhole
slots (A) .
15 . Mount the jet wiper mounting posts to the back panel of the printer through the
keyhole slots .
NOTE: Slide the mounting pins downward .
3D Systems, Inc. 12
A
A