3D Systems CubePro User Manual page 32

NOTE: If the print file requires ABS material and PLA material
is installed, the printer will prompt the user to change the
cartridge(s) . Select
titled Replacing A Material
NOTE: If the print file requires ABS material but PLA is installed,
the printer will prompt you to change the material cartridge . Select
CANCEL and follow the instructions in the section titled
A Material Cartridge .
NOTE: If there is not enough material in the cartridge to complete
the print, the printer will prompt the user to replace the cartridge .
Select CHANGE CARTRIDGE
section titled Replacing A Material
NOTE: If the creation file uses color(s) that are not installed,
selecting the checkmark
of the print to a color currently installed . You can also change
the cartridge by selecting
CARTRIDGE instructions . To change the cartridge, refer to the
section titled Replacing A Material
3D Systems, Inc.
CHANGE CARTRIDGE and refer to the section
Cartridge .
and follow the instructions in the
Cartridge .
will enable the printer to change the color
BACK and following the
Cartridge .
Replacing
CHANGE
28