tecan ls series Operating Manual page 73

Resolution
Resolution
group box
Tecan Connect Configuration
2004-11 Operating Manual for the LS Series Scanner No. 30001798 Rev. No. 1.5
Scan Resolution combo box displays a selection of possible resolution of 4,
6, 10, 20 and 40 µm.
The Scan Resolution is the number of µm per pixel in the x and y directions.
The smaller the value, the higher is the resolution of the image but the more
time it takes to perform a scan and the larger is the image file.
In the Measurement Control dialog box, select the General tab. Click
Configuration... and the Connect Configuration dialog box appears, in which
the plate settings and the number of plates used for the Demo Mode can
selected.
Click OK to close the dialog box and save the selected options.
•
Plates group
box
•
•
Laser Handling Two check boxes are available:
•
•
•
Demo Mode
combo box
Click the OK button to save the selected options and to close
OK
button the dialog box
6. LSServer, Scanner Shell and Download
Read plate barcode
Enabled if Tecan Connect is installed with barcode
reader. If the checkbox is checked, a plate barcode will
be read.
Don't read top most plate
If this box is checked the topmost plate will be ignored for
stacking ( e.g. topmost plate can be used as light shield )
Restack after last plate
If this box is checked, Tecan Connect will
automatically restack all plates from output stack to
input stack.
Start batch run only after all lasers have reached
warm-up time
Switch off laser after batch run has finished
Number of plates
Enter the number of slides to be processed in
Demo Mode. Maximum is 50. These setting will be
ignored if the Tecan Connect instrument is connected.
6-43