tecan ls series Operating Manual page 100

6. LSServer, Scanner Shell and Download
Move Plate and Filter...
Edit Measurement Parameters...
Start Measurement
Disconnect
6-70 Operating Manual for the LS Series Scanner No. 30001798 Rev. No. 1.5
In the Instrument menu, select Move Plate and Filter... and the Movements
dialog box appears.
In the Movements dialog box, specific In and Out buttons can be used to drive
the plate carrier or filter slides into or out of the LS Series Scanner. Click OK to
close the dialog box.
For further information refer to the chapter Plate/ Filter on page 6-26 description
in this manual.
In the Instrument menu, select Edit Measurement Parameters... or on the
toolbar click the Edit Parameter button or press Ctrl + F5 and the Measurement
Parameter dialog box appears.
In the Measurement Parameter dialog box general options like Scan Mode,
Stacker and/or Barcode as well as Geometry Parameters and Scan Settings can
be defined.
For further information refer to the chapter Edit... on page 6-28 in this manual.
The Start Measurement option is not available in the Instrument menu of the
Scanner Shell software.
In the Instrument menu, select the Disconnect option to disconnect the currently
connected instrument. Another instrument can then be connected.
This option is only available, if an instrument is already connected.
Note
2004-11