tecan ls series Operating Manual page 112

6. LSServer, Scanner Shell and Download
Stacker Setup...
6-82 Operating Manual for the LS Series Scanner No. 30001798 Rev. No. 1.5
Stacker Setup is only used when Tecan LS Scanner is connected to a special
autoloader, the Twister . If the Tecan Connect is associated with the LS Scanner,
than a special XConnect software, which is delivered with the instrument, is
responsible for the calibration and configuration of the connected autoloader
Connect .
For further information about using Connect , refer to the Connect manual.
In the Service menu, select Stacker Setup... and the Stacker Setup dialog box
is displayed:
The Tecan LS SCANNER instrument can operate in manual and automatic
mode. For automation purposes, a stacker instrument such as the Twister must
be connected.
For further information about using Twister refer to the Twister manuals: The
Twister User's Guide and The Twister Service Manual .
The Stacker Setup dialog box helps the user select, calibrate and configure the
installed stacker instrument.
For further information about Stacker Setup refer to the chapter 6.4.7 Stacker
Setup - Twister description in this manual.
In the Stacker Setup dialog box the user can choose between several options
setting up the connected stacker instrument:
Click the Port Setup button to display the Port Setup dialog box: Stacker type
and communication port can be selected.
Click the Stacker Configuration button to display the Stacker Configuration
dialog box, the corresponding to the connected stacker instrument.
Click the Stacker Settings button to display the Stacker Settings dialog box, the
corresponding to the connected stacker instrument.
Click the Stacker Calibration button to display the Stacker Calibration dialog
box which corresponds to the connected stacker instrument.
The Stacker Setup dialog box contains the following elements:
Port Setup button
Stacker Configuration
button
Stacker Settings
button
Stacker Calibration
button
Click the Port Setup button to display the Port Setup
dialog box.
Click the Stacker Configuration button to display the
Stacker Configuration dialog box.
Click the Stacker Settings button to display the
Stacker Settings dialog box.
Click the Stacker Calibration button to display the
Stacker Calibration dialog box.
2004-11