SENSOR PDS / DPS
Note: Sensor DPS is for duplex model only.
1. Remove the Chassis FBS. (See page 5-32)
2. Remove five Frame upper mounting screws, and then remove the Frame upper.
3. Remove the Sensor stopper and disconnect the connector, and then remove the SENSOR PDS/DPS.
Ground wire
Sensor stopper
ROLLER EXIT
1. Remove the Chassis FBS. (See page 5-32)
2. Remove the Frame upper.
3. Remove one E-ring, and then remove the BRG exit.
4. Slide out the ROLLER EXIT.
Note: When reattaching the BRG exit, align its cutout with the cutout of the Frame upper's holder.
TX gear 20
Ground wire
Sensor DPS
Frame upper
Roller exit
Frame upper
Sensor PDS
Sensor stopper
BRG Exit
5-53
5-53
BRG Exit
E-ring