Muratec F-315 Field Engineering Manual page 95

Memory Switch 20 – Reception
Initial
Switch
Setting
7 0 Data error rate
0: 10%
1: 20%
6 0 Pause one second after
sending CED
0: No (75 ms)
1: Yes (1 sec)
5 0 Factory use only
4 0 Factory use only
3 1 Receive speed (kbps)
Maximum receive speed may be slowed to compensate for poor phone lines.
2 1
2.4 4.8 7.2 9.6 12 14.4 16.8 19.2 21.6 24 26.4 28.8 31.2 33.6
1 0
0
0 1
0
0
0
Memory Switch 21 – Reception
Initial
Switch
Setting
7 0 Not used
6 0 DIS "inch" declaration
0: No
1: Yes
5 0 Paper size limitation
0: No limit
1: 3m
4 0 T1 timer
0: 35 sec
1: 20 sec
3 1 Print image data when post
message is not received after
receiving RTC signal
0: No
1: Yes
2 0 DIS/DTC Extend field
Transmit
0: Yes
1: No Tx until Bit No.24 of
DIS/DTC
1 0 G3 echo receive
0 1
Adjusts the delay between detection of training/TCF and sending of CFR.
Switch 1
Switch 0
Memory Switch 22 ––– Factory use only
Adjust
0 0 0 0 0 0
0 0 0 1 1 1
0 1 1 0 0 1
1 0 1 0 1 0
Adjust
100 ms 500 ms 800 ms 1200 ms
0 0
0 1
3-69
Usage/Comments
Determines the allowable number of erred lines out
of total lines received in a document.
A 2100 Hz CED signal disables echo suppression in
some telephone equipment. When set to "1", the
machine pauses one second after sending CED,
which allows echo suppression to restart. This may
help with problematic overseas reception.
0 1 1 1
1 0 0 0
1 0 0 1
1 0 1 0
Usage/Comments
This will limit the paper length of the received
document. Setting this bit to "1", the paper will be
cut when the length reached to 3m.
Adjusts the T1 time–out. After the machine dials the
remote machine's phone number, it begins sending
CNG and waits this amount of time before
disconnecting the line.
If the received document includes the RTC, the
machine prints the data even though the following
protocol is not succeeded.
Setting this switch to "1" will disable ITU– T
superfine mode.
1 1
0 1
1 1 1
0 1 1
1 0 0
1 0 1