Muratec F-315 Field Engineering Manual page 117

Unique Switch 10 – Transmission
Initial
Switch
Setting
7 1 Factory use only
6 0 Factory use only
5 1 Factory use only
4 0 Factory use only
3 1 Including TTI inside the
document
0: No
1: Yes
2 0 Factory use only
1 1 The number of times PPR is detected during ECM transmission
1 time 2 times 3 times 4 times
0 1 0
0
Unique Switch 11 ∼ 15 – Factory use only
Unique Switch 16 – Transmission
Initial
Switch
Setting
7 1 Available *, # and space
upon F–code box registration
0: No
1: Yes
Available *, # and space
upon F–code communicating
6 1
0: No
1: Yes
5 0 Ignore space in F–code ID
0: Yes
1: No
4 1 F–code sub–frame off
0: Send
1: Not send
3 0 Send F–code box's TTI
0: No
1: Yes
2 0 Factory use only
1 0 Retrieve document
0: No
1: Yes
0 1 Ignore F–code bit
0: No
1: Yes
Note: The "F–code communication" is possible the SecureMail and Polling operation using the F–code
(SUB/SEP/PWD/SID). However, it is not based on T.33 recommendation.
Adjust
Setting this bit to "0" transmit the document length
added with the TTI. Setting it to "1" transmit the
length including TTI inside the document. However
in this case, the image at the top of the document
might be overlapped with TTI.
(TTI length: 4.2mm)
0 1 1
1 0 1
Adjust
Determines if the * (asterisk), # (sharp) and space
are available upon F–code box registration.
Determines if the * (asterisk), # (sharp) and space
are available upon F–code communicating.
Determines if checking the space stored in the
F–code ID.
Do not send the sub–address and password of F–
code box when a point of sending DCS signal after
EOM signal.
Transmit the sub–address and box name of F–code
box with F–code polling document.
Retrieve the document received in F–code
SecureMail box by polling transmission.
Neglect SEP bit of DTC signal or SUB bit of DCS
signal at F–code polled transmission.
3-91
Usage/Comments
Usage/Comments