Clearing Jammed Paper; If The Original Document Jams - Muratec F-315 Field Engineering Manual

4.11 Clearing Jammed Paper

If the original document jams

1. If an original document jams in the ADF while scanning the document into the memory for faxing or
copying, the LCD will show:
Document Jam
ContStor Enter/Cancl
If you do wish to continue the operation, press <Enter> and proceed to step 2.
To abort the operation, press <Cancel>. This will erase from memory all pages stored during this
operation, and the machine will return to standby mode.
Important: If you wait more than 60 seconds without pressing any key, the machine will erase all
pages from memory stored during this operation and the machine will return to the
standby mode.
Note: If the document jammed in the following case, the following message will appear and the
machine will abort the operation anyway; instead, you'll have to perform the job again from
scratch.
• The first page of the document jammed
• During the real time transmission or quick memory transmission
• During non-sorting ADF job
Open&Close ScanCover
Reset Document
Also, the "Repeat transmission. Error on scan at page xx" message will be printed out if the
document jammed during transmission.
2. The LCD will show which page (i. e., which page number) is jammed. To continue scanning from
the jammed page forward (keeping in mind the Note at the end of step 1, above), press <Start>
after clearing the jam.
P 2.Reset Document
Press Start Key
Note: If you wait more than 60 seconds without pressing any key, the machine will begin to send or
copy the document(s) it has.
If you wish to cancel this operation, press <Stop>. The machine will delete all pages from memory
and then return to its standby mode.
4-5