Low Power Mode - Datalogic PowerScan RF Programming Manual

Low Power
Mode
RF Programming Manual
When enabled, Low Power Mode causes the scanner to powerdown
completely between trigger pulls. This results in very low idle current,
lowering the energy needs of the scanner. It does, however, require the
scanner's microcontroller to reboot with every trigger pull. This will
introduce a very small delay in scanning when this mode is enabled.
Therefore, it is recommended that this mode only be used when the
scanner is connected to a battery powered terminal.
NOTE
Scan these labels to enable and set the Low Power Mode.
SET ------------------------------------------
Enable Step #1
Enable Step #2
Disable Step #1
Disable Step #2
END ------------------------------------------
The state of this feature is not affected by the
RETURN TO FACTORY DEFAULTS program-
ming bar code. It must be manually enabled
or disabled using the programming bar codes
below.
---------
---------
---------
---------
185