Setting Global Suffix(Es) - Datalogic PowerScan RF Programming Manual

Setting Global
Suffix(es)
RF Programming Manual
One or two suffix characters may be added to the standard label format
when desired. For the addition of more than two suffix characters, con-
tact your distributor or technical support representative for Full Label
Edit (FLE) options.
Identify your specific system requirements before adding or modifying
these settings, then follow these steps:
1. Look at the ASCII chart shown on the inside back cover of this
manual, and identify the ASCII character(s) and the corre-
sponding Hex Code(s) for the ASCII characters you will use as
suffixes.
For example, if you are going to send two suffix characters as 'LF' (Line
Feed) and 'CR' (Carriage Return). The ASCII chart shows that 'LF'
equals 0A hex and 'CR' equals 0D hex.
2. Scan the SET bar code on page 60.
3. Scan the Set Suffix bar code.
4. Turn to Appendix C: Keypad on page 193, and scan the four digits
corresponding to the Hex Values determined in step one
above. (For the example, scan 0, A, 0, D), then go to step five.
IMPORTANT NOTE
NOTE
NOTE
If you are using the Universal Wedge interface,
do not modify the suffix setting. Refer to the
Universal Wedge Programming Guide to mod-
ify the suffix setting.
If you make a mistake or lose your place while
setting this option, scan the END bar code to
exit Programming Mode. The scanner will
sound a two-beep error tone to indicate that
programming was incomplete, and the setting
will remain as it was before entering Program-
ming Mode.
Successful programming of a suffix requires
4 digits.
59