Software
Handshaking
34
Xon/Xoff - is software handshaking that allows the host to control data
transmission. If the host sends an Xoff command to the scanner, the
scanner will not send the bar code data until it receives an Xon com-
mand from the host. If the host sends the Xoff command during data
transmission, the host will receive additional characters for no more
1
than 2ms
.
Scan the SET bar code label then the Step #1, Step #2 below, followed
by the END bar code labels to enable Xon/Xoff Control.
Enable Xon/Xoff Control
SET -----------------------------
Step #1
---------
Step #2
---------
END -----------------------------
Transmit Scanner
Configuration to
Base Station
---------
1. Timing varies slightly depending upon the baud rate selected.
®
PowerScan
RF Scanner