Datalogic PowerScan RF Programming Manual page 111

Variable
Length
Format
RF Programming Manual
Follow the steps below to set the Codabar symbology to Variable
Length Format.
1. Identify the minimum length setting you want to make. The
selectable range is 03 to 50
2. Scan the SET bar code below.
3. Scan the ENABLE VARIABLE LENGTH FORMAT bar code.
4. Scan the SET MINIMUM LABEL LENGTH bar code.
5. Set the minimum label length by scanning the correct digits
from page 108. Return to this page and go to step six.
NOTE
6. Scan the END bar code.
Variable Length Format
SET ------------------------------------------
Enable Variable Length
Format
Set Minimum Label
Length
END ------------------------------------------
1. For this symbology, the scanner will decode up to 50 characters, but the actual length read will
vary depending upon the interface type, and bar code physical size and quality.
1
characters.
If you are setting a label length less than ten,
you must scan a zero digit first and then the
length digit (e.g., 04, 06, 08).
---------
---------
105