32
Handshaking controls are mutually exclusive. The settings below
allow only one of these features to be enabled at a time, as enabling
multiple controls will produce unpredictable results.
NOTE
Scan the SET bar code label then the Step #1, Step #2 below, followed
by the END bar code labels to enable CTS/RTS Flow Control.
Enable CTS/RTS Flow Control
SET ------------------------------
Step #1
---------
Step #2
---------
END -----------------------------
Transmit Scanner
Configuration to
Base Station
---------
Each of the handshaking features requires a
series of bar codes to be read (Step #1, Step
#2) in the sequence given. That is, you must
enter Programming Mode by scanning the
SET bar code, scan the bar codes required to
set one handshaking feature, then scan the
END bar code.
®
PowerScan
RF Scanner