Read Time-Out; Manual Trigger, Low Power; Low Power Time-Out Timer - Datalogic PowerScan 7000 2D Product Reference Manual

Trigger Modes
When in serial mode, the imager scans until a bar code has been read or
until the deactivate command is sent. In serial mode, the imager can also
be set to turn itself off after a specified time has elapsed (see
Read Time-
, which follows).
Out
* Manual/Serial Trigger

Read Time-Out

Use this selection to set a time-out (in milliseconds) of the imager's trig-
ger when using serial commands to trigger the imager, or if the imager is
in manual trigger mode. Once the imager has timed out, you can acti-
vate the imager either by pressing the trigger or using a serial trigger
command. After scanning the Read Time-Out bar code, set the time-out
duration (from 0-300,000 milliseconds) by scanning digits from the
Pro-
, then scanning Save. Default = 0 (infinite,
gramming Chart on page B-5
or no time-out).
Read Time-Out

Manual Trigger, Low Power

The imager powers down until the trigger is pulled. When the trigger is
pulled, the imager powers up and operates until there is no triggering for
the time set with the Low Power Time-Out bar code below. There is a
delay of up to one second in operation when the imager is first triggered,
but there is no delay when operating in low power time-out mode.
Manual Trigger, Low Power

Low Power Time-Out Timer

Scan the Low Power Time-Out bar code to change the time-out dura-
tion (in seconds). Then scan the time-out duration (from 0-300 sec-
onds) from the , and Save. Default =
Programming Chart on page B-5
120 seconds.
Product Reference Guide 3-5